BBQ Shelter
PARTS:
- A side panels – posts – (4) 4 X 4 X 6′ 11 1/2″ (see dwg)
- B side panels – rails – (4) 2 X 4 X 33″ (cut shorter if using rail connectors)
- C side panels – fence boards – (6) 1 X 6 X 2′ 7″ (cut from 6′ fence boards)
- D side panels – top rail & shelf – (2) 2 x 6 x 3′ 4″ (see dwg)
- E back panel – frame – (5) 2 x 4 x 5′
- F back panel – filler pieces – (8) two 1 x 6 x 5′ fence boards ripped to 1 1/4″ wide strips
- G back panel – shutter boards – (12) 1 x 6 x 5′ (cut lengths to accommodate louvre brackets & rails)
- H roof – ridge boards – (2) 2 X 6 X 3′ (see dwg)
- I roof – rafters – (4) 2 X 4 X 3′ 4 1/2″ (see dwg)
- J roof – shutter boards – (18) 1 X 6 X cut length to fit (6′ fence boards cut in half)
- K roof – peak – (2) 2 x 4 x 1′ 8″ (see dwg)
- L roof – cap – (2) 1 x 6 x 3′ (see dwg)
ROOF – ASSEMBLY
Fasten the louvre brackets and misc parts to the shutter boards and install the boards according to the manufacturer’s instructions.
Fasten the roof cap to the ridge boards and the rafters. Lift the roof structure onto the four posts. Set the rafters into the post notches. Fasten the rafters to each post with four 3 1/2″ deck screws.
ROOF – PARTS
ROOF – STRUCTURE
Fasten 2 rafters to each ridge board using 3 1/2″ deck screws. Install louvre rails on the insides of the 4 rafters.
Screw or bolt the two ridge boards together. Fasten the two roof peak pieces “K” to the bottoms of the rafters.
BACK PANEL
Install the louvre rail sections to the insides of the frame (top and bottom) according to the manufacturer’s instructions. Screw vertical filler pieces “F” to the insides of the frame to fill in the gaps at the ends of the louvre rails. Fasten the louvre brackets and misc parts to the shutter boards and install the boards according to the manufacturer’s instructions.
ASSEMBLY – BACK & SIDE PANELS
Fasten the back panel to the side panel posts with 3 1/2″ deck screws.
SIDE PANELS
Fasten the top rails “D” to the side panels with 3 1/2″ deck screws.
BACK PANEL
Assemble the back panel frame using 3″ deck screws.
POSTS
In two posts, slope the notches in one direction and in the other two posts, slope the notches in the opposite direction.
SIDE PANELS
Construct two side panel assemblies:
- Fasten the rails to the posts using rail connectors.
- Make certain that the post notches in
each panel face inward. - Also, make certain that the post notches
slope in the correct direction for the
roof structure
The original plan can be found at http://www.homeathome.homehardware.ca